DEITY GRIP BODY KIT- LOCKJAW (NO CLAMPS)
- Have you worn out your DEITY LOCKJAW GRIPS? Replace your grip bodies for a minimal cost by reusing your existing clamps and purchasing a DEITY Grip Body Kit!
- The DEITY Grip Body Kit includes a PAIR of replacement grip bodies so you can reuse your existing DEITY clamps and refresh your set up
- The DEITY Grip Body Kit does not include clamps! Reuse your existing clamps or purchase a pair of DEITY Clamps separately
- Padded thumb area for comfort and smooth transitions
- Recessed half waffle design for added control without hot spots
- Deep dish DEITY diamond pattern compresses for comfort but also provides unrivaled traction
- Featuring soft DEITY TRC+ rubber compound for durability and increased grip
- Tapered inner sleeve to insure perfect contact with the handlebar
- Seamless transition through the end of the grip for comfort
- Capped end for safety and comfort
- 133mm length with 32mm outer diameter
- INSTALLATION TIP: To fully and properly install your LOCKJAW grip due to the tapered inner sleeve...make certain to whack the end of the grip 3 times with the palm of your hand until the grip fully seats onto the handlebar. If you find the fit is a bit tight due to your particular handlebar, a small amount of Isopropyl Alcohol can work wonders for lubrication. Finish the install by tightening the hardware to the specs listed on the packaging.
- Not compatible with bar ends or plugs
[FREE SHIPPING AT $50 IN THE USA]