DEITY GRIP BODY KIT- KNUCKLEDUSTER (NO CLAMPS)
- Have you worn out your DEITY KNUCKLEDUSTER GRIPS? Replace your grip bodies for a minimal cost by reusing your existing clamps and purchasing a DEITY Grip Body Kit!
- The DEITY Grip Body Kit includes a PAIR of replacement grip bodies so you can reuse your existing DEITY clamps and refresh your set up
- The DEITY Grip Body Kit does not include clamps! Reuse your existing clamps or purchase a pair of DEITY Clamps separately
- Featuring DEITY TRC rubber compound for exceptional durability
- Tapered inner sleeve to insure perfect contact with the handlebar
- Short and wide rib design for added comfort with no side to side play
- Half waffle recessed design for added control without hot spots
- Chevron v-channel design for your palm swell to give an ergonomic feel
- Seamless transition through the end of grip for comfort
- 132mm length with 32mm outer diameter
- Intended use: All MTN / Enduro / DJ / Slopestyle and DH
- Full color range available in Black, Stealth, Red, Green, Blue, Orange, Turq, Gum, Pink, Purple, Shaolin Yellow, and Mint
- INSTALLATION TIP: To fully and properly install your KNUCKLEDUSTER grip due to the tapered inner sleeve...make certain to whack the end of the grip 3 times with the palm of your hand until the grip fully seats onto the handlebar. If you find the fit is a bit tight due to your particular handlebar, a small amount of Isopropyl Alcohol can work wonders for lubrication. Finish the install by tightening the hardware to the specs listed on the packaging.
- Not compatible with bar ends or plugs
[FREE SHIPPING AT $50 IN THE USA]